Tram Engine - WIP(8) - RC aerial positioning....

The positioning of the RC aerial in the interior of the loco body needed a bit of work....

The aerial position on the chassis...

 I had a hole cut in the base of the loco body for the aerial to go through, but needed a good location for it as I added in the interior detail. I used part of the inner tube from a toilet roll for the boiler top and fitted the casing of an old biro to hold the aerial....

 Another hole was made in the roof for the aerial casing to go through - the idea is that it could represent a whistle or safety valve ....

now I can finish off the rudimentary internal details....