Project Railbus (8) - Finishing off and Test Run

 The completed seating module...

The headlamps at the front/rear, get a cosmetic lift using some parts of lamps of an old LGB loco ..

The control consoles for each end painted grey with the control section left in the original colour.

All the parts ready for assembly....

During first fit assembly, the sides of the body tended to move inwards at the bottom, slightly distorting the final look. A piece of 2mm cardboard was added to either side of the seating module to stop 'inward drift'.

The fully assembled rail-bus on the garage layout...

Plus a little test run....